◎ 型號含義 Type meaning
① 可控硅調壓 SCR voltage regulator
② 閉環穩壓 Closed-loop stabilizer
③ 負載電壓 220V 或 380VAC Load voltage 220V or 380VAC
④ 15A,25A,40A,50A,70A,90A,120A,150A,200A
⑤ 控制電壓 0-5VDC Control voltage 0-5VDC
⑥ 控制電流 4-20mA Control current 4-20mA
◎ 產品概述 Product overview
◆ 額定電流：15A-200Amps
◆ 額定電壓：220V/380VAC（可選）
◆ 無需外接 +12V 直流電源
◆ 增設閉環（負反饋）穩壓系統，能有效穩定電壓波動
◆ 絕緣介質電壓大于 2000VAC
◆ 支持 4-20mA, 0-5V 自動控制模式，也可手動控制，調節平滑
◆ 內置屏蔽電路，抗力強
◆ 采用大功率晶閘管芯片和 DCB 陶瓷釉鋅絕緣底板材料
◆ 性能穩定，可靠性高
◆ Rated current: 15A-200Amps
◆ Rated voltage: 220V/380VAC (optional)
◆ No external +12V DC power supply required
◆ Effectively stabilize voltage fluctuations with closed-loop (negative feedback) voltage regulator system
◆ Insulation voltage greater than 2000VAC
◆ Support automatic control mode (control signal 4-20mA, 0-5V) and manual control mode, and both modes are smooth to adjust
◆ Built-in shielding circuit with strong anti- interference ability
◆ THigh-power thyristor chip, and insulating base plate with DCB ceramic glaze material
◆Stable performance and high reliability
注意 :
1. 當負載電流為 10A 時 , 必須加裝散熱器 ; 為 40A 及以上時 , 必須加風扇強冷或水冷 .
2. 使用感性負載時 , 務必在輸出端并接一個壓敏電阻 , 取值為負載電壓的 1.6-1.9 倍 .
Notice:
1. If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.
2. When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.
◎ 安裝尺寸及接線圖 Installation dimensions and wiring diagram
